A Step-By-Step Guide to Fix Large Hole in Plaster Wall
Homes are one of the essential places which need to be updated from time to time. Before the use of drywalls became widespread, many homes in today’s era are featured with plaster walls. As the plaster walls give various benefits, but it comes with one major disadvantage. It takes a matter of time for your home’s plaster wall to accumulate with the large holes and dents.
The large hole in plaster walls not only gives a bad impression but also dangerous for your whole home. Then what to do? usually, as you see the large hole in plaster walls, you try to take help from the professional which charges hundreds of dollars. However, there are ways to keep your money safe and fix the large hole in plaster walls.
From using the metal furring system to making the right moves, you can easily fix large holes in plaster walls all by yourself. Let’s follow the simple steps that will enable you to fix the large hole perfectly.
1. Choose Tools and Material:
To fix a large hole in the plaster wall it is important to determine the required tools and material. You will be needed a plaster towel, sandpaper, utility knife, 10’’ drywall knife, ball pen hammer, sandpaper block, and cold chisel. After getting these tools, you will be needed three essential materials to fix your plaster wall. Joint compound, plaster mix, and mesh drywall tape.
To hold the finish material, you can use metal furring, that helps you to create seamless plaster internal finish.
2. Use Scrapper to Prep the Area:
When starting to fix a large hole in the plaster wall, you will need to remove any loosing or flaking plaster. To do that, you need to use scrappers, cold chisel, and ball pen hammer. Through scrapper chip away the excess debris, while chipping away the damaged plasters through chisel and ball pen hammer. This will help you to prep the area and make the surface smooth for the working.
3. Get off with New Plaster:
When you are done with the scrapping the next step is to place the new plaster. But be careful to use new plaster. The majority of the time, people put extra plaster to fix the large hole in plaster walls. This never gives good outcomes. Therefore, mix up only the amount of plaster that is needed for the repair.
To ensure the proper mixture, follow the instructions written on the packaging of the plaster. Remember to mix it to the consistency of frosting.
4. Apply The Plaster Mix:
When your plaster is ready, it is time to apply it to the damaged area. Use 10’’ wallboard knife and spread ¼ inch layer over the hole. When the first layer begins to set, cross scratch it to allow the second coat to adhere well.
5. Apply Joint Compound:
Once the coat is dried, you need to apply a joint compound to fix a large hole in plaster walls. First, mix the compound according to the manufacturer’s instructions, and then apply it thinly using the wallboard knife. Remember to paint the wall once the area is dried.
